Quantcast
Channel: ToManual.com » Search Results » blend door actuator for 1998 monte carlo
Viewing all articles
Browse latest Browse all 10

1997-2003 Honda CRV Signal Mirror Manual Installation Instructions

0
0

Download
Door Panel & Mirror Housing Removal 2002-2003 Honda CRV:1. Open door and lower window. 2. Remove plastic cover from corner of door. 3. Pop-out and remove plastic inserts. 4. Remove door handle plastic cover. 5. Unscrew the (2) screws revealed by the removal of the door handle cover. 6. Pry out door handle as shown. Disengage latch behind door handle and remove door handle. 7. Remove the (2) screws beneath armrest. 8. Lift up and pull door panel out slightly as shown. Disconnect any wiring connection behind door panel. Remove door panel from door. 9. Unscrew the (3) nuts holding the mirror housing to the door. Remove mirror housing from door.
Door Panel & Mirror Housing Removal 1997-2001 Honda CRV : 1. Open door and lower window. 2. Remove screw and plastic grommet on inside corner of door. 3. Remove plastic cover from corner of door. 4. Disconnect the mirror wire harness. 5. Remove three mirror mounting nuts. 6. Remove mirror housing assembly from door.
Mirror Replacement 1997-2003 Honda CRV: 1. While using sturdy gloves, insert a small pry bar underneath the mirror at the bottom edge of the mirror housing. Lift up on the bottom of the mirror to release it from the snaps. 2. Pivot the mirror upward on its top edge and lift the mirror out of the mirror housing. 3. Carefully remove the foam insulation from the mirror housing sail. 4. NOTE: In order to make room for the Signa l® mirror optics about 1/4″ of the left edge of the mirror mount will need to be removed. Use a pair of side cutters and begin cutting at the left edge of the mirror mount, starting in the upper left corner. Continued removal of any mirror mount surface (interfering with Signal® mirror optic) may be necessary. 5. Continue cutting down alongside the left edge of the mirror mount and discard the excess molding. 6. Carefully peel back the plastic screw covers on the bottom of the mirror bracket. Remove the three screws that hold the mirror bracket in place. 7. Using the shorter of the two wires from the kit, starting from the inside of the mirror housing, guide the end without the mating connector down alongside the existing factory mirror harness.


Viewing all articles
Browse latest Browse all 10

Latest Images

Trending Articles





Latest Images